Download update KB You need your original installation CD for this procedure. When you have the CD ready, follow these steps:. Make sure your video adapter has the latest driver available installed. Read more at Windows Recovery Disks. The NeoSmart Support Forums , member-to-member technical support and troubleshooting. Get a discounted price on replacement setup and installation discs: Windows XP. Please check the Windows documentation about hardware disk configuration and your hardware reference manuals for additional information.
If you start the computer to the Recovery Console, a command prompt may appear with no option to log on to the Windows installation. Edit the Boot. For more information about how to edit the Boot.
When you receive the message to press R to repair Windows by using the Recovery Console, press the R key. Select the Windows installation that you want, and then type the administrator password when prompted.
Add installation to boot list? After you perform the preceding steps, restart the computer, and then select the first item on the boot menu. This should allow Windows XP to start normally.
After Windows XP has successfully loaded, the Boot. Note The system management interrupt SMI is handled by the firmware, not by the operating system. In some situations, there is not an explicit signaling mechanism and the operating system must poll the error status registers to test for an error condition.
However, polling can only be used for corrected error conditions because uncorrected errors require immediate attention by the operating system. Starting with Windows Vista, the operating system maintains a list of all of the hardware error sources that can be discovered on a particular hardware platform. WHEA uses a discovery mechanism when the operating system starts to determine which of these hardware error sources exist on a particular system. The means by which this information is exposed to the operating system is platform-specific.
The operating system collects this information from a combination of ACPI tables, firmware interactions, and other platform-specific mechanisms. Get the fix to the Windows could not start boot error message affecting Windows XP.
The following information on this error has been compiled by NeoSmart Technologies, based on the information gathered and reported by our global network of engineers, developers, and technicians or partner organizations. When a computer is turned on, the BIOS picks an eligible, bootable hard drive and then calls code stored in the MBR at the start of that hard drive. That MBR code in turn loads the bootsector from the active partition.
However, if an entry in the Boot.
0コメント